1# 2# WIZnet devices configuration 3# 4 5config NET_VENDOR_WIZNET 6 bool "WIZnet devices" 7 depends on HAS_IOMEM 8 default y 9 ---help--- 10 If you have a network (Ethernet) card belonging to this class, say Y 11 and read the Ethernet-HOWTO, available from 12 <http://www.tldp.org/docs.html#howto>. 13 14 Note that the answer to this question doesn't directly affect the 15 kernel: saying N will just cause the configurator to skip all 16 the questions about WIZnet devices. If you say Y, you will be asked 17 for your specific card in the following questions. 18 19if NET_VENDOR_WIZNET 20 21config WIZNET_W5100 22 tristate "WIZnet W5100 Ethernet support" 23 depends on HAS_IOMEM 24 ---help--- 25 Support for WIZnet W5100 chips. 26 27 W5100 is a single chip with integrated 10/100 Ethernet MAC, 28 PHY and hardware TCP/IP stack, but this driver is limited to 29 the MAC and PHY functions only, onchip TCP/IP is unused. 30 31 To compile this driver as a module, choose M here: the module 32 will be called w5100. 33 34config WIZNET_W5300 35 tristate "WIZnet W5300 Ethernet support" 36 depends on HAS_IOMEM 37 ---help--- 38 Support for WIZnet W5300 chips. 39 40 W5300 is a single chip with integrated 10/100 Ethernet MAC, 41 PHY and hardware TCP/IP stack, but this driver is limited to 42 the MAC and PHY functions only, onchip TCP/IP is unused. 43 44 To compile this driver as a module, choose M here: the module 45 will be called w5300. 46 47choice 48 prompt "WIZnet interface mode" 49 depends on WIZNET_W5100 || WIZNET_W5300 50 default WIZNET_BUS_ANY 51 52config WIZNET_BUS_DIRECT 53 bool "Direct address bus mode" 54 ---help--- 55 In direct address mode host system can directly access all registers 56 after mapping to Memory-Mapped I/O space. 57 58config WIZNET_BUS_INDIRECT 59 bool "Indirect address bus mode" 60 ---help--- 61 In indirect address mode host system indirectly accesses registers 62 using Indirect Mode Address Register and Indirect Mode Data Register, 63 which are directly mapped to Memory-Mapped I/O space. 64 65config WIZNET_BUS_ANY 66 bool "Select interface mode in runtime" 67 ---help--- 68 If interface mode is unknown in compile time, it can be selected 69 in runtime from board/platform resources configuration. 70 71 Performance may decrease compared to explicitly selected bus mode. 72endchoice 73 74endif # NET_VENDOR_WIZNET 75