1PPC440SPe DMA/XOR (DMA Controller and XOR Accelerator) 2 3Device nodes needed for operation of the ppc440spe-adma driver 4are specified hereby. These are I2O/DMA, DMA and XOR nodes 5for DMA engines and Memory Queue Module node. The latter is used 6by ADMA driver for configuration of RAID-6 H/W capabilities of 7the PPC440SPe. In addition to the nodes and properties described 8below, the ranges property of PLB node must specify ranges for 9DMA devices. 10 11 i) The I2O node 12 13 Required properties: 14 15 - compatible : "ibm,i2o-440spe"; 16 - reg : <registers mapping> 17 - dcr-reg : <DCR registers range> 18 19 Example: 20 21 I2O: i2o@400100000 { 22 compatible = "ibm,i2o-440spe"; 23 reg = <0x00000004 0x00100000 0x100>; 24 dcr-reg = <0x060 0x020>; 25 }; 26 27 28 ii) The DMA node 29 30 Required properties: 31 32 - compatible : "ibm,dma-440spe"; 33 - cell-index : 1 cell, hardware index of the DMA engine 34 (typically 0x0 and 0x1 for DMA0 and DMA1) 35 - reg : <registers mapping> 36 - dcr-reg : <DCR registers range> 37 - interrupts : <interrupt mapping for DMA0/1 interrupts sources: 38 2 sources: DMAx CS FIFO Needs Service IRQ (on UIC0) 39 and DMA Error IRQ (on UIC1). The latter is common 40 for both DMA engines>. 41 - interrupt-parent : needed for interrupt mapping 42 43 Example: 44 45 DMA0: dma0@400100100 { 46 compatible = "ibm,dma-440spe"; 47 cell-index = <0>; 48 reg = <0x00000004 0x00100100 0x100>; 49 dcr-reg = <0x060 0x020>; 50 interrupt-parent = <&DMA0>; 51 interrupts = <0 1>; 52 #interrupt-cells = <1>; 53 #address-cells = <0>; 54 #size-cells = <0>; 55 interrupt-map = < 56 0 &UIC0 0x14 4 57 1 &UIC1 0x16 4>; 58 }; 59 60 61 iii) XOR Accelerator node 62 63 Required properties: 64 65 - compatible : "amcc,xor-accelerator"; 66 - reg : <registers mapping> 67 - interrupts : <interrupt mapping for XOR interrupt source> 68 - interrupt-parent : for interrupt mapping 69 70 Example: 71 72 xor-accel@400200000 { 73 compatible = "amcc,xor-accelerator"; 74 reg = <0x00000004 0x00200000 0x400>; 75 interrupt-parent = <&UIC1>; 76 interrupts = <0x1f 4>; 77 }; 78 79 80 iv) Memory Queue Module node 81 82 Required properties: 83 84 - compatible : "ibm,mq-440spe"; 85 - dcr-reg : <DCR registers range> 86 87 Example: 88 89 MQ0: mq { 90 compatible = "ibm,mq-440spe"; 91 dcr-reg = <0x040 0x020>; 92 }; 93 94